XACTA FENCE II™ COMMERCIAL 30/50
Note: This manual also runs through the steps of installing the rails, and extension table.
WARNING
Disconnect the table saw from the power source before attempting any assembly or adjustment!
Failure to comply may cause serious injury!
Contents of the Shipping Containers | Tools Required for Assembly & Adjustment | |||
1 | XACTA FENCE II™ | 1 | #3 Cross Point Screwdriver | |
1 | Front Rail | 1 | 7/16” Wrench | |
1 | Rear Rail | 1 | 1/2" Wrench | |
1 | Guide Rail | 1 | Combination Square & Straight Edge | |
3 | Black Plastic End Caps | 1 | Electric Drill | |
1 | Hardware Package | 1 | 1/4”, 3/16” Drill Bits | |
1 | Owner’s Manual | 2 | ||
1 | Warranty Registration Card | 1 | 1/4”, 3/16” Allen Wrenches | |
Front and Rear Rail Assembly |
|
|
| |
Note: The hardware should be packed in the guide rail along with the end caps.
Assembly Note: Depending on the size of the extension table you are using, you may need to remove the right side extension wing. You need to have four bolts attaching the extension table to the front and rear rails. Use a JET extension table or one designed and built by the operator. If you are planning to build a table, see Figure 1 for the dimensions.
1.Bolt the front rail to the table (not to the extension wing at this time) with two
2.Setting the combination square at 9/16” will clear the miter gauge slot.
3.Place the combination square on the table and adjust the rail to approximately 9/16” below the table surface, see Figure 2. Note: It is more important to have the front rail parallel to the table top than exactly 9/16” below the table top.
4.Tighten hex cap screws.
3
