Guide Rail Assembly
1.Bolt the guide rail to the front rail with
2.Measure from the front of the guide rail to the front of the tablesaw table in a couple spots to verify that the guide rail is parallel to the table. Adjust as needed and tighten.
Fence Assembly and Adjustments
1.Thread the handle knob into the cam assembly.
Note: Fence adjustments should be performed in the order given.
Level with the Saw Table
1.Place the fence on the table and lock it.
2.View the fence from the left side of the saw. Look for the space between the table and the fence bottom to be equal along the entire length of the fence.
3.If adjustment is necessary, unlock the fence.
4.Raise or lower two nylon adjustment screws (A, Fig. 4) the same number of turns until the space between the bottom of the fence and the table is the same. Care must be
taken to raise or lower the fence on each side equally or the fence may not be 90° to the table after the height adjustment is performed.
Parallel to the Miter Slot
1.Place the fence next to the outside edge of the right miter slot and lock it.
2.The fence should be even with the miter slot from front to back.
3.If the fence is not even along the length of the miter slot, unlock the fence, remove it and turn upside down.
4.Adjust one of the two set screws (A, Fig. 5) until the fence is even with the miter slot edge along its entire length when locked.
Note: You may need to
Clamping Pressure
The XACTA FENCE II™ has been adjusted at the factory to lock securely when the lock handle is pushed down. If adjustment is needed:
1.Unlock the fence.
2.Remove the fence from the guide rail.
3.Turn the fence over.
4.Adjust the two set screws (A, Fig. 5) until the fence is held securely when the lock handle is pushed down.
5
