90° to the Table
1.Place the fence on the saw table and lock it.
2.Place a square on the table next to the fence. The fence should be 90° to the table, Figure 6.
3.If adjustment is necessary, unlock the fence, and turn one of the two nylon
adjustment screws (A, Fig. 7) until the fence is 90° to the table.
4.Lock the fence and check the adjustment again.
Cursor Adjustment
1.Disconnect the table saw from the power source.
2.Raise the saw blade above the tabletop.
3.Unlock the fence and slide it to approximately four inches from the saw blade.
4.Lock the fence.
5.Measure the distance between the saw blade and the inside of the fence.
6.Adjust the cursor to read the distance just measured and tighten the cursor assembly to the fence.
7.Take a test cut and confirm the adjustment is correct.
Note: If the cursor does not have enough travel to give the correct measurement loosen the guide rail and adjust as needed. If you still do not get the correct measurement loosen the front rail and adjust as needed. If you have to adjust the front rail you will need to go through the front rail assembly instructions again.
This adjustment must be checked whenever a different blade is installed.
After installing the XACTA FENCE II™ press the black plastic end caps into the openings of the guide rail. There is also an end cap for the fence, but this should already be installed.
6
