Changing Operating Frequency
If several devices are controlled by the same type remote control unit, each remote control unit can be set to operate at its’ own unique operating frequency as follows:
Referring to Figure 14:
1.Unplug the
2.Remove the back covers of the main unit (A) and remote control switch (B).
3.Locate the DIP switch (C) in each unit.
4.Change the position of the DIP switches in the main unit (A) to any combination desired as long as they are not the same as other units that may be present and located within the radio frequency range.
5.Set the DIP switches (C) in the remote control switch (B) to match the switch settings in the main unit (A).
6.Replace the back covers to the main unit and remote control switch.
7.Operate a device as described in Turning the
Figure 14
Installing the DC-RC Remote Power
Control (Optional Accessory)
The
To mount the
Note: Mounting hardware is not included and must be supplied by the machine’s owner or user.
1.Place RC Power Control Unit (A) on the open clearing of the base (B) of the dust collector near the motor (C).
2.Using a marker, mark the base through the mounting holes of the power control units mounting tabs.
3.Drill two holes (D) through the base where marked.
4.Insert screws through the tabs and base. Place washers and hex nuts on the threaded ends of the screw underneath the base and tighten.
Figure 15
14
