Maintenance
WARNING
Never performmaintenace on this machine before turning switch off and removing plug from power source, unplug.
Failure to comply may cause serious injury!
Cleaning the Filter Bag
CAUTION
Wearing aparticle mask/respirator for
protection against fine dust particles during
cleaning is highly recommended.
During first use and after cleaning, the filter bag may allow some dust to escape. This is normal and will stop after a short period of time.
Clean both the filter and collector bags frequently to keep the collector's performance at its optimum. To clean:
1. Disconnect the machine from the power source.
2. Unhook the filter bag from the hanger and shake the bag so that the majority of the dust falls into the collector bag.
3. Loosen the retaining strap, and remove the filter bag from the housing.
4. Turn the bag inside out and clean.
5. Turn the bag outside in and
Removing the Collector Bag
1.Disconnect the machine from the power source, unplug.
2.Remove the collector bag by pushing the ring of the collector bag upwards and pulling the bag out at an angle.
3.Empty the contents into an appropriate container.
4.Turn the bag inside out and clean.
5.Turn the bag outside in and insert into the housing.
Use the proper type hose to connect the dust collector to the machine being operated. Dryer vent hose is not acceptable for this purpose. Contact your nearest JET distributor for the full line of JET Dust Collector Hoses and Accessories. Customize your installation and obtain maximum performance with JET's dust hoods, hoses, clamps, fittings, and blast gates. Accessories.
Motor
Make frequent inspections of the motor fan and blow out (with low pressure air hose) or vacuum any accumulation of foreign material in order to maintain normal motor ventilation.
Connecting the Dust collector to a Machine
Use the proper type hose to connect the dust collector to the machine being operated. Dryer vent hose is not acceptable for this purpose. Contact your nearest JET distributor for the full line of JET Dust Collector Hoses and Accessories. Customize your installation and obtain maximum performance with JET's dust hoods, hoses, clamps, fittings, and blast gates.
You can also purchase the JET “Dust Collection Basics Video” stock # JW1050V through your JET Distributor
Grounding the Dust Collection System
The dust collection system includes the dust collector and the hose, or duct work you use to connect the tools. The dust collector is grounded though the ground wire in the cord. The hose or duct work you use to connect the tool to the dust collector must also be grounded. To assist in grounding your system you can purchase the JET “Dust Collector Grounding Kit” stock # JW1053, and also the JET “Dust Collection Basics Video” stock # JW1050V through JET Distributors.
9
