Jet Tools JWP-16OS owner manual Starter Box, Handwheel, Extension Rollers, Dust Collection Hood

5.Mount the handle (C, Fig. 4) for the handwheel in the threaded hole in the handwheel, and tighten with a wrench placed over the flat (12mm) on the handle.

Figure 2

Starter Box

The switch assembly (starter box and bracket) is pre-assembled at the factory and simply needs to be mounted to the head casting on the left side of the machine with two socket head cap screws (A, Fig. 3) already in place the head casting.

Figure 3

Handwheel

1.Remove the tape holding the key in the shaft.

2.Place the handwheel (B, Fig. 4) onto the shaft; making sure it is oriented so the handwheel slips over the key.

3.Remove the adhesive backing from the direction label supplied with the hardware bag for the handwheel. Place the label onto the shaft and press it on the handwheel (D, Fig. 4).

4.Place flat washer and hex nut on shaft and tighten with wrench.

Figure 4

Extension Rollers

Mount two extension rollers to the table using the provided 6 ea M8 x 20 hex cap screws (12mm), 6 ea M8 flat washers, and 6 ea M8 x 12 set screws (A, Fig. 5). The rollers should be adjusted before operating the planer (this will be explained later in the Adjustment section).

Figure 5

Dust Collection Hood

Referring to Figure 6:

The dust collection hood (A) comes standard with the model JWP-16OS planer, and helps maintain a clean and safe work area. It is assembled to the planer (B) with six hex head screws (C) as shown.

10