7.Thread a M6 hex nut onto the filter bag support rod, follwed by a M6 flat washer and M6 lock washer (A, Fig. 5). Thread the support rod (B, Fig. 5) into the motor/fan housing and tighten nut against housing.

8.Place the retaining strap (C, Fig. 5) through the loops on the filter bag and hang the filter bag from the hook.

9.Secure bag to housing with retaining strap.

Note: The retainer strap should be tight enough to provide a good seal.

10.Insert the snap ring of collector bag into the bottom of housing at an angle, see Figure 6.

11.Pull down on the ring and bag to make sure it “seats” in the housing.

Note: make sure the snap ring “snaps” into place in the housing.

Cleaning the Filter Bag

CAUTION

Wearing a particle mask/respirator for

protection against fine dust particles during

cleaning is highly recommended.

During first use and after cleaning, the filter bag may allow some dust to escape. This is normal and will stop after a short period of time.

Clean both the filter and collector bags frequently to keep the collector's performance at its optimum. To clean:

CAUTION

Wearing a particle mask/respirator for

protection against fine dust particles during

cleaning is highly recommended.

1.Disconnect the machine from the power source.

2.Unhook the filter bag from the hanger and shake the bag so that the majority of the dust falls into the collector bag.

3.Loosen the retaining strap, and remove the filter bag from the housing.

4.Turn the bag inside out and clean.

5.Turn the bag outside in and re-attach to the housing using the retainer strap to secure.

9

Page 9
Image 9
Jet Tools M-708640 owner manual Cleaning the Filter Bag