Assembly
WARNING
The dust collector must be disconnected from the power source during assembly. Failure to comply may result in serious injury!
1.Place motor housing on the floor with the motor fan facing upwards as shown in Figure 1.
2.Attach support cylinder (A, Fig. 2) to the motor housing with three M6x16 socket head cap screws and three M6 flat washers (B, Fig. 2).
3.Mount two fixed casters (C, Fig. 3) to the appropriate end of base (D, Fig. 3) using four M6 flat washers (E, Fig. 3), four M6 lock washers (F, Fig. 3) and four M6x12 hex cap bolts (G, Fig. 3).
4.Mount two swivel casters (H, Fig 3) to the appropriate end of the base with two 3/8” hex nuts (I, Fig. 3), four M10 flat washers (J, Fig. 3), and two 3/8” acorn nuts (K, Fig. 3).
5.Mount support canister (L, Fig. 4) to base (M, Fig. 4) with four M8x12 hex cap bolts and four flat washers (N, Fig. 4).
6.Turn the dust collector over onto the casters. Note: Make sure the base and housing are relatively parallel. If not loosen the screws that secure the support cylinder to the motor and adjust as necessary. Tighten all hardware.
8
