Model W1831 (For Machines Mfg. Since 2/12)
Assembly
Place the spindle hex nut, table inserts, sanding drums and sleeves, and spindle washers in the appropriate sized accessory slots beneath the table.
Note: A sanding drum does not need to be installed until after the test run.
Table Inserts
Sanding Drums
and Sleeves
SETUP
Dust Collection
Recommended CFM at Dust Port: | 100 CFM |
Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must take into account many variables, including the CFM rating of the dust collector, the length of hose between the dust collector and the machine, the amount of branches or Y's, and the amount of other open lines throughout the system. Explaining this calculation is beyond the scope of this manual. If you are unsure of your system, consult an expert or purchase a good dust collection
DO NOT operate this machine without an adequate dust collection system. This machine creates substan- tial amounts of wood dust while operating. Failure to use a dust collection system can result in short and
