Model W1831 (For Machines Mfg. Since 2/12)
Tools Required: | Qty |
Screwdriver Phillips #2 | 1 |
To change motor brushes: |
|
1.DISCONNECT SANDER FROM POWER.
2.Turn machine on its side, and remove the screws securing the base plate, then remove the base plate to allow access to the motor.
3.Disconnect the wire attached to the motor brush assembly.
4.Loosen the screws that secure the clamp plate over the brush assemblies (see Figure 16) but do not completely remove the plate.
5.Gently pull the brush assembly straight toward you and then upward to remove it.
6.Install new motor brush assembly.
7.Tighten the clamp plate back in place.
8.Repeat these steps to change the second motor brush assembly.
9.Reconnect the wire to the motor brush.
10.Replace the base plate.
Motor Brushes |
Clamp Plates |
