Model W1831 (For Machines Mfg. Since 2/12)
ELECTRICAL
Circuit Requirements
This machine must be connected to the correct size and type of power supply circuit, or fire or electrical damage may occur. Read through this section to determine if an adequate power supply circuit is available. If a correct circuit is not available, a qualified electrician MUST install one before you can connect the machine to power.
A power supply circuit includes all electrical equipment between the breaker box or fuse panel in the building and the machine. The power supply circuit used for this machine must be sized to safely handle the full- load current drawn from the machine for an extended period of time. (If this machine is connected to a circuit protected by fuses, use a time delay fuse marked D.)
Full-Load Current Rating
The
3.5 Amps |
The machine must be properly set up before it is safe to operate. DO NOT connect this machine to the power source until instructed to do later in this manual.
Incorrectly wiring or grounding this machine can cause electrocution, fire, or machine damage. To reduce this risk, only an electrician or qualified service personnel should do any required electrical work on this machine.
ELECTRICAL
Circuit Requirements for 110V
This machine can be converted to operate on a 110V power supply (details about voltage conversion can be found later in this manual). The 110V power supply circuit must have a verified ground and meet the requirements that follow:
Circuit Type | 120V, 60 Hz, |
Circuit Size | 15 Amps |
Plug/Receptacle | NEMA |
NOTICE
The. circuit. requirements. listed. in. this. manual. apply. to. a. dedicated. circuit— where.only.one.machine.will.be.running. at. a. time.. If. this. machine. will. be. connected. to. a. shared. circuit. where. multiple.machines.will.be.running.at.the. same.time,.consult.with.an.electrician. to. ensure. that. the. circuit. is. properly. sized.for.safe.operation.
