Machine Preparation
12.Set up machine following instructions in The Basics section, pages
Cleansing Formula™ in the SmartMix® tank.
13.Check ReadyTools™ switch - it should be set on Floor Cleaning.
14.Choose the SmartMix® setting to match the cleaning job.
15.Plug into a proper outlet and turn Power Switch ON. Turn SmartTemp™ switch to ON. The SmartTemp™ Ready Light illuminates when POWERSTEAMER® PROHEAT™ PLUS is ready to clean.
Bare Floor Cleaning Technique
17.Slowly move the machine nozzle with Bare Floor Tool forward and back over soiled surface one time while pressing the trigger.
Caution: Do not over wet.
18.Repeat the motion without pressing the trigger using the Bare Floor Tool to squeegee and suction up the dirty water.
19.Repeat steps 1 and 2 backing along the exit path.
20.Allow about 30 minutes for the floor to dry completely.
21.When the cleaning job is complete refer to the Maintenance/Putting it Away section, page 14, for machine cleanup and storage instructions.
22.To remove Bare Floor Tool gently bend long tab (right side) outward and pull tool down away from nozzle. Rinse thoroughly, dry and store.
Keep plenty of genuine BISSELL Fiber Cleansing Formula™ on hand so you can clean whenever it fits your schedule. Always use genuine BISSELL deep cleaning formulas.
13