Troubleshooting - continued
Dirtlifter® PowerBrush® does not turn. |
|
Possible Causes | Remedies |
The Brush Belt or Pump Belt may be broken.
Turn the machine OFF and unplug from the outlet. To check if a Brush Belt has broken,
you will need a flat head screwdriver. Insert the blade end into the lower slot of the Belt Access door to release the lower snap. If necessary, insert the blade end into the upper slot to release the upper snap. Examine for belt breakage. The Brush Belt should be visible, looped around the motor shaft.
If it is broken or missing, please refer to Part Numbers and Descriptions on page 17 before calling Consumer Services. Complete installation instructions will accompany the replacement belt.
Vacuum not picking up solution. |
| |
| Possible Causes | Remedies |
| ReadyTools™ switch may be at the | Set ReadyTools™ switch to either Tools or |
| wrong setting for the cleaning job. | PreTreat or Floor Cleaning. |
| Drain cap may be missing or not | Remove |
| properly installed at back of | |
|
| |
| ||
| properly installed. |
|
Poor tool position. | Adjust angle; apply more downward pressure. |
(Hand held attachments only). |
|
Empty | |
maximum dirty water. | The Basics section. |
16