Drum Guard & Dust Port
Referring to Figure 6:
Mounting the Drum Guard & Dust Port (referred to below as drum guard)
1.Insert four M4x20 flat head screws (A) through the two hinges (B) of the drum guard (C). Then place two rectangular spacers (D) on the threaded ends of the screws.
Note: Orient the spacers so the slightly rounded side sits against the hinge and the edge farther from the screws lines up with the edge of the hinge.
2.Secure the drum guard (A) to the belt guard on the rear side of the sander by threading the screws through the mounting holes (E) in the belt guard. Tighten the screws.
Mounting the Connection Plate
3.Place the drum guard (C) in the closed position
– this will cover the drive drum (J).
Note: You may have to slightly lift the cover when closing in order to clear the motor case. This is normal.
4.Place washers (G) on two small lock knobs (H) and then insert the threaded end of one lock knob through the slot of the connection plate (F) and the other lock knob through the hole of the connection plate.
5.Secure the slotted side of the extension plate to the drum guard (C) and the side with the hole to the belt guard (E).
When repositioning the drum guard, slightly loosen both lock knobs, open or close the cover, then secure the lock knobs.
Extension Table
Referring to Figure 7:
1.Attach the bracket (E) for the extension table to the side of the motor housing (D) and secure with two socket head cap screws (F).
2.Slide the shaft of the extension table (C) into the bracket (E), positioning the table so the opening (B) wraps around the drive drum (A).
3.Insert lock knob (G) into the threaded hole on the side of the bracket (E) visible from the rear of the sander.
10
Figure 6
Figure 7
