2) Turn on the machine by pressing the line button | and the machine will start to charge water. Wait for |
the water to come out of the rinse arms.
Caution: if the tank door is not closed, the machine will not charge the water, so check the door by looking inside the machine baskets outlet.
3) Now the booster tank should be full, so start the quick heating of the booster. Turn off the machine, open one of the machine doors, and at the same time press buttons C and D for a few seconds until the wording Key 00 appears.
4)Go to Key 01 by pressing button C and confirm with D.
5)The wording QUIK READY NO will appear afterwards. Press C to change the status to Yes.
Keep the line button | pressed until you see this again: | . Then |
and the quick heating will be activated. Lastly, wait until the machine is completely filled. |
|
4.7 Adjusting the controls
The table below indicates the requirements and default settings of the dishwasher:
minimum washing temperature | 170 | °F (75°C) |
minimum rinsing temperature | 190 | °F (88°C) |
intensive washing program (speed 1) | 150 | racks/h |
quick washing program (speed 2) | 200 | racks/h |
Filling hose | 26.4 mm (3/4") | |
Max. incoming water temperature | 140 | °F (60 °C) |
Min. incoming water pressure | 100 kPa (14.5 psi) | |
Max. incoming water pressure | 345 kPa (50 psi) | |
Water hardness (recommended) | 6 (French degrees) | |
Water flow rate | 20 l/min. (5.3 gpm) |
For viewing the temperatures and operating times:
By keeping the C button pressed for approximately 4 seconds, the instant temperature of the booster and of the tank can be viewed. The number of daily hours and of the machine's working totals of the machine’s life will also run across the display.
6