If the appliance is not used for a prolonged time, lubricate the steel surfaces using liquid paraffin.
Have the booster and washing pump drained completely by an expert so as to prevent ice formation.
If the machine is not working correctly or in case of failure, contact an authorised service centre.
6.3DOS AND DO NOTS WITH THE DISHWASHER
MAKE SURE that the water hardness is correct MAKE SURE that the dishes have been
MAKE SURE that only the detergents recommended by a chemistry expert are used
MAKE SURE that the machine is cleaned thoroughly, rinse it and let it dry (leaving the doors open) at the end of the day
MAKE SURE that the lime removal programme recommended by a chemistry expert is followed. MAKE SURE that only products especially formulated for stainless steel are used.
DO NOT exceed with the detergent, sanitiser, rinsing or
DO NOT use steel wool to clean the items to be washed or the dishwasher surface. DO NOT let foreign bodies, especially metal contaminants, enter the machine.
DO NOT use the dishwasher without filters.
NOTE: failure to follow the use, care and maintenance instructions may cancel the warranty.
6.4Self-diagnosis
The machine is able to recognise various alarm or malfunction situations. Every malfunction is signalled by messages generated on the display; the L lamp lights up and the machine runs in "safe mode", i.e. with limited functions.
Error code | Message displayed | description |
ER 02 | TANK WATER DRAIN | The alarm is displayed when the drain motor pump cannot drain the |
| FAILED | tank correctly. For example, the overflow was not removed or the |
|
| main drainage is clogged. |
ER 03 | BOOSTER HEATING FAILED | Problem in the booster resistances. When this message is |
|
| displayed, the booster heating and thermostop are automatically |
ER 04 | LOADING FAILURE | The alarm is displayed when the machine does not load water |
|
| properly. |
ER 05 | TANK PROBE | This alarm means that the tank temperature sensor is not working |
| OPEN | properly. |
ER 06 | TANK PROBE | This alarm means that the tank temperature sensor is not working |
| properly. | |
ER 07 | BOOSTER PROBE | This alarm means that the booster temperature sensor is not |
| OPEN | working properly. |
ER 08 | BOOSTER PROBE | This alarm means that the booster temperature sensor is not |
| working properly. | |
ER 09 | LOADING FAILURE | The alarm is displayed when the booster does not load |
| OF BOOSTER | water properly. |
HIR | BOOSTER TEMPERATURE | The alarm is displayed when the booster temperature is too high. |
| TOO HIGH |
|
HIW | TANK TEMPERATURE | The alarm is displayed when the tank temperature is too high. |
| TOO HIGH |
|
SA FE |
| This alarm is displayed when any safety temperature thermostat |
|
| has intervened. |
WNC | REPLACE TANK | This message is displayed when the wash water has not been |
| WATER | replaced for 1 working day. |
|
| A drain cycle is required. |
ER 23 | TANK HEATING FAILED | Problem in the tank resistances. When this message is displayed, |
|
| the tank heating and thermostop are automatically disabled. |
CAP.7 DISMANTLING
Machine dismantling
There are no materials on our machines that require special disposal procedures.
1
4