4.3 Plumbing connections:
To connect the dishwasher to the water network make sure that:
There is a “gate valve” that is able to interrupt the water supply when necessary or in case of repair.
A supply pipe has been envisaged for each user in order to avoid any load or pressure drops.
A pressure reducer complete with
Then connect the filling solenoid valve to the water supply tap using the hose provided.
4.4 Connection to the drainage :
The tank empties by gravity, so the drain must be at a lower level than the machine base.
Connect the machine drains to the sewer system using pipes that resist a constant temperature of 80°C.
The drain spigot must be connected to a well or a water trap in the floor by a flexible pipe drain.
4.5 Limit switch connection:
The table below indicates the requirements and default settings of the dishwasher:
Mount the limit switch (found on the side panel of the machine) on the outfeed
surface.
4.6 Commissioniing (filling the Booster Tank):
It is necessary to carry out the following Booster Tank filling operation during the installation phase.
1)Energize the machine using the
The machine emits a beep and displays the uploaded software version, after which some dashes as shown in the figure appear.
5