2 | JL Audio - C2-600x Owner’s Manual
3
C2-600x sPeCiFiCaTions:
Woofer: Injection-molded, Mica-filled, Polypropylene Cone,
Butyl Rubber Surround, 1 in. Voice Coil on Kapton® Former,
Flat, Symmetrical Roll Spider, Ferrite Magnet
Tweeter : 0.75 in. (19 mm) Silk Dome, Ferrofluid Cooling /
Damping, Neodymium Magnet
Crossover: Natural Roll-Off Low-Pass, 1st Order High-Pass
Filter with Electrolytic Capacitor
Continuous Power Handling: 60 Watts
Recommended Amp Power: 15-100 Watts per channel (RMS)
Efficiency: 90.5 dB @ 1W/1m | 96.5 dB @ 1W/0.5m
Sensitivity: 93.5 dB @ 2.83V/1m
Nominal Impedance: 4 ohm
Frequency Response: 59 Hz - 22 KHz ± 3 dB
Included Components and Parts:
• Two C2-600x 6.0-inch (150mm) Coaxial loudspeakers
• Two Grille Assemblies
• Eight #8 x 1 1/4-inch (30mm) sheet metal screws
• Eight Mounting Clips
• Two 5.2 mm female crimpable connectors
• Two 2.8 mm female crimpable connectors
• Two self-adhesive JL Audio logo name badges
GeTTinG sTarTeD
•Turnofftheaudiosystem.Itisalso
advisabletodisconnectthenegative(–)
terminalofyourvehicle ’sbatterywhenever
performinginstal lationwork.
•Beforecutting,drillingorinsertinganyscrew,
checkclearancesonbothsidesoftheplanned
mountingsurface.Al socheckforanypotential
obstacles,such��aswindowtracksandmotors,
wiringharnesses,etc.Checkbothsidesofthe
vehicle,manyvehiclesare notsymmetrical!
•Alwayswearprotectiveeyewear.
sPeaKer PlaCemenT ConsiDeraTions
Inmostcases,yourspeakerswillbeplacedinto
factoryspeakerlocations.Ifyouhavesomespeaker
mountingflexibil ity,keepthefollowingin mind:
Lowermountinglocations,s uchasthelowerfront
cornerofadoororakick-panelprovidethegreatest
pathlengthdistancesforthesoundemittedbythe
speakers.Forthisreason,theyaregenerallymore
desirablethanhighermountinglocations.Higher
mountinglocationswil lusuallyresultin extreme
near-sidesoundstagebiaswhichcompromisesthe
stereolisteningexperience.