JL Audio SB-D-MAG/10W3v3 manual Stealthbox, On Next

Stealthbox®

I N S T A L L A T I O N G U I D E

for the

SB-D-MAG/10W3v3

(fits 2005-Up Dodge Magnum)

START

HERE

➔ ➔ ➔

STEP 1: Remove all contents from the dri- ver’s side rear cargo pocket.

STEP 2: Remove the paper backing from the supplied wax square. Place the wax square 6” from the front wall and 2-1/2” from the left(outer) side wall.

STEP 3: (a)Place the supplied Socket Cup Set Screw into the bottom of the Stealthbox®, leaving about 1/2” exposed. Make sure that the cup side of the screw is exposed to the outside.

(b)Place the Stealthbox® into place. Press firmly down onto the enclosure.This is to make an impression on the wax square. Remove the Stealthbox®.

If there is no impression on the wax square, back out the Socket Cup Set Screw further and repeat STEP 3:(b).

This Stealthbox is a product which requires professional installation skills and tools.

Please read this installation guide thor- oughly before beginning the project. It will guide you step by step through the installation. Several of the steps in this process may require two people to accomplish.

➔ ➔ ➔

It is absolutely vital that the enclosure be properly mounted to the vehicle according to these instructions. Failure to mount the enclosure properly pres- ents two problems: 1) The sub-bass performance will suffer due to the movement of the enclosure caused by the force exerted by the woofer(s) and

2)A loose enclosure presents a serious safety hazard in the event of a collision or sudden deceleration.

Please enjoy your JL Audio Stealthbox responsibly.

STEP 4: *CAUTION*

Before drilling, make sure that you are not going to be drilling into any gas lines, brake lines, transmission lines, electrical wiring, transfer case(4x4 vehicles) or anything else that might cause a reduction in your weekly pay. Always wear eye protection when drilling.

With the use of a 1/2” drill bit and drill. Drill out the floor at the impression on the wax square.

STEP 5: Run speaker wire from the amplifi- er’s location to the Stealthbox’s® location.

STEP 6: (a)Attach the speaker wire to the Stealthbox® terminal.

(b)Back out the Socket Cup Set Screw to expose 1-1/2”.

Continued on Next Page ➔

w w w . j l a u d i o . c o m SB - D - MAG/10W3v3, JL AUDIO, Inc 2006, Inc 2006 Pag e 1 Sheet SKU#011204 1/18/2006