Cont.
From
Previous
Page
➔
STEP 13(B): You can use different cutting tools.
Here we used a cutting wheel.
3/4”
➔
STEP 13(C)
➔
➔
STEP 14: Use a sanding wheel or just sand paper to clean off the edge off the cut.
1-1/4”
STEP 15: Back inside the SUV, Look into the area that the Stealthbox is going to reside.There is a metal lip to the left. On this lip there is an exposed hole. Measure 3/4” from the middle of this hole down and mark.
STEP 16: There is a metal lip to the right. On this lip there is also an exposed hole. Measure
STEP 17: | *CAUTION* |
|
Before drilling, make sure that you are not going to |
| |
be drilling into any electrical wiring or anything else |
| |
➔ that might cause a reduction in your weekly pay. |
| |
Always wear eye protection when drilling. |
| |
With the use of a 1/2” drill bit and drill. Drill at the |
| |
marks from STEPs 14 & 15. | Continued on Next Page ➔ | |
w w w . j l a u d i o . c o m
SB - N - ARMDA/10W6v2, JL AUDIO, Inc 2005 | Pag e 3 | Sheet SKU#011193 Revision 5/26/2005 |
