JL Audio SB-S-LWAG/10W6v2/DG SB-S-LWAG/10W6v2INSTRSKU#011207, From inside the vehicle, E P 1

S T E P 4

Remove the pair of screws that secure the passenger’s side rear taillight.

S T E P 5

Remove the taillight assembly from the wiring harness.

Pull the wire harness out of the pass through hole.

S T E P 6

Apply the supplied wax square into place. The left side is lined up with the left edge of the pocket opening and above the emboss portion of the inner lower corner.

S T E P 7

Thread the supplied socket cup set screw into the Stealthbox®, leaving 1/4-inch of thread exposed.

SB-S-LWAG/10W6v2_INSTR_SKU#011207

S T E P 8

Position the Stealthbox® in the mounting location and press on it firmly.

Remove the Stealthbox® carefully, leaving the wax squares in place. The socket cup set screws will leave impressions in the wax.

S T E P 9

Note: Before drilling, make sure that you are not going to be drilling into electrical wiring or anything else that might cause a reduction in your weekly pay. Always wear eye protection when drilling!

From inside the vehicle.

With a drill and a 1/4-inch drill bit, drill at the same angle as the impression on the wax square. Drill through the plastic panel and metal body. Remove the wax square.

With a 3/8-inch drill bit, enlarge the pilot hole.

S T E P 1 0

From the outside of the vehicle.

Place the 3/8-inch drill bit through the pass through hole, enlarge the pilot hole.

S T E P 1 1

Run speaker wire from the amplifier location to the Stealthbox® location.

Page 2 • JL Audio, Inc 2006 Continued on Next Page