JL Audio XD600/6 owner manual Planning Your Installation, Cooling Efficiency Considerations

Planning Your Installation

It is important that you take the time to read this manual and that you plan out your installation carefully. The following are some considerations that you must take into account when planning your installation.

Cooling Efficiency Considerations:

The outer shell of your JL Audio amplifier is designed to remove heat from the amplifier circuitry. For optimum cooling performance, this outer shell should be exposed to as large a volume of air as possible. Enclosing the amplifier in a small, poorly ventilated chamber can

lead to excessive heat build-up and degraded performance. If an installation calls for an enclosure around the amplifier, we recommend that this enclosure be ventilated with the aid of a fan. In normal applications, fan-cooling is not necessary.

Mounting the amplifier upside down is strongly discouraged.

If mounting the amplifier under a seat, make sure there is at least 1 inch (2.5 cm) of space above the amplifier’s outer shell to permit proper cooling.

Safety Considerations:

Your amplifier needs to be installed in a dry, well-ventilated environment and in a manner which does not interfere with your vehicle’s safety equipment (air bags, seat belt systems, ABS brake systems, etc.). You should also take the time to securely mount the amplifier so that it does not come loose in the event of a collision or a sudden jolt to the vehicle.

Stupid Mistakes to Avoid

•Check before drilling any holes in your vehicle to make sure that you will not be drilling through a gas tank, brake line, wiring harness or other vital vehicle system.

•Do not run system wiring outside or underneath the vehicle. This is an extremely dangerous practice which can result in severe damage to your vehicle and person.

•Protect all system wires from sharp metal edges and wear by carefully routing them, tying them down and using grommets and loom where appropriate.

•Do not mount the amplifier in the engine compartment, under the vehicle, on the roof or in any other area that will expose the amplifier circuitry to the elements.

ENGLISH

Chassis Ground

Channels 1 & 2

Channels 5 & 6

Connector

Preamp Input Jacks

Preamp Input Jacks

(pg. 5)

(pg. 7)

(pg. 7)

Jack for

+12 V Power

Remote Turn-On

Channels 3 & 4

Remote Level

Channels 1 & 2

Channels 3 & 4

Channels 5 & 6

Connector

Connector

Preamp Input Jacks

Control Knob

Speaker Outputs

Speaker Outputs

Speaker Outputs

(pg. 5)

(pg. 6)

(pg. 7)

(pg. 9)

(pg. 10)

(pg. 10)

(pg. 10)

3