b) Setting electronically
The dishwasher must be switched off
NOTE: the electronic setting of the water softener is possible ONLY with the
The dishwasher is factory set at level 5.
1.Press the On/Off button.The indicator lights of the programme selection buttons will illuminate (setting mode). If only one programme button indicator light is on, this means that a washing programme is set.The programme must be cancelled: press simultaneously function buttons 2 and 3 for about 2 seconds. All programme indicator lights will illuminate indicating that the set programme has been cancelled and the machine is now in setting mode.
2.Press simultaneously function buttons 2 and 3, until the indicator lights of function buttons 1, 2, and 3 start flashing.
3.Press function button 1, the indicator lights of function buttons 2 and 3 turn off while the indicator light of function button 1 goes on flashing, the digital display indicates the current level and a sequence of intermittent audible signals are heard. The current level is indicated by the number visible in the display and the number of intermittent audible signals heard.
Example:
displayed + 5 audible signals = level 5.
4.To change the level, press function button 1. Each time the button is pressed the level changes. (For the selection of the new level see the chart).
Examples:
if the current level is 5, by pressing function button 1 once, level 6 is selected.
if the current level is 10, by pressing function button 1 once, level 1 is selected.
5.To memorise the operation, switch off the dishwasher by pressing the On/Off button.
Filling with dishwasher salt
Only use salt specifically designed for use in dishwashers. All other types of salt not specifically designed for use in a dishwasher, especially table salt, will damage the water softener.
Only fill with salt just before starting one of the complete washing programmes.
This will prevent any grains of salt or salty water, which may have been spilt, remaining on the bottom of the machine for any period of time, which may cause corrosion.
To fill:
1.Open the door, remove the lower basket and unscrew the cap of the salt container by turning it anticlockwise.
2.Pour 1 litre of water inside the container (this is necessary only before filling with salt for the first time).
3. Using the funnel provided, pour in the salt until the container is full.
4. Replace the cap making sure that there is no trace of salt on the screw thread or on the gasket.
5.Replace the cap tightly
turning it clockwise until it stops with a click.
The salt container will require topping up periodically.You are reminded of this by the salt indicator light on the control panel which comes on when the salt has finished.
The salt indicator light on the control panel can remain illuminated for
Do not worry if water over flows from the unit when filling with salt, this is quite normal.
13
