Apply covers
Snap vent grille (B) and hinge cover (E) into position.
Separate parts Ha, Hb, Hc, Hd as shown in the figure.
Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes.After having drilled holes, fix the guide with the screws supplied.
Fix cover (Hc) on guide (Ha) until it clips into place
Open the appliance door and the furniture door at 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. Remove the squares and drill holes with ø 2 mm at 8 mm from the outer edge of the door. Place the small square on the guide again and fix it with the screws supplied.
10
D | C |
|
| E |
|
|
| B |
| Ha | Hb |
Hc
Hd
PR266
ca. 50 mm
|
| 90° |
|
|
| 2 |
|
|
| 1 m | |
|
|
| m |
| ca. 50 mm | 2 |
|
|
|
| |
|
| 1 m | |
|
|
| m |
| Ha |
|
|
| Hc |
|
|
| 8mm |
|
|
|
|
| Ha |
PR167 | Hb |
|
|
|
|
| |
Should the lining up of the furniture door be necessary, use the clearance of slots.
At the end of operations, it is necessary to check if the door of the furniture closes properly.
Fix cover (Hd) on guide (Hb) until it clips into place.
After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting.
Hb |
PR168 |
Hb
Hd
PR167/1
11
