John Lewis JLBILIC02 Hints and Tips, Installation, Technical Data, Heating elements rating

Models: JLBILIC02

1 10
Download 10 pages 39.16 Kb
Page 6
Image 6
Installation

Installation

Technical Data It is dangerous to alter the specifications or attempt to modify this product in any way.

Heating elements rating Care must be taken to ensure that the appliance does not stand on the electrical supply cable.

Technical Data

Dimensions of recess

 

Height

1780 mm

Width

560 mm

Depth

550 mm

Dimensions of the appliance cavity

Height

1772 mm

Width

540 mm

Air recycling Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

Heating elements rating

Supply voltage (50 Hz)

220-240 V

Connected load,

120 W

Fridge light

25 W

Air recycling

The refrigerator compartment is equipped with a special D.A.C.(Dynamic Air Cooling) fan which can be turned on with the switch (fig. 1).The green light, when on, means that the fan is working.

It is suggested that the fan (D.A.C.) be used when the ambient temperature exceeds 25°C .

This device allows for rapid cooling of foods and a more uniform temperature in the compartment.

Fig. 1

SWITCH

Depth

547 mm

Fridge Gross capacity

332 litres

 Hints and Tips Hints and Tips

Fridge Net capacity

330 litres

 Electrical connection Electrical connection

Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person.

WARNING:THIS APPLIANCE MUST BE EARTHED.

The manufacturer declines any liability should this safety measure not be observed.

If the plug that is fitted to your appliance is not suitable for your socket outlet, it must be cut off and the appropriate plug fitted.

Remove the fuse from the cut off plug.

The cut off plug should then be disposed of to prevent the hazard of shocks in case it should be plugged into a 13amp socket in another part of your home.

Food Storage Important

The wires in the mains lead are coloured in accordance with the following code:

Green andYellow

- Earth

Blue- Neutral

Brown- Live

If you fit your own plug, the colours of the wires in the mains lead of your appliance may not correspond with the markings identifying the terminals in your plug,

proceed as follows:

GREEN & YELLOW

13 AMP. FUSE

 

13 AMP

 

BROWN

 

BLUE

D207

CORD CLAMP

 

1.Connect the Green and Yellow (earth) wire to the terminal in the plug which is marked with the letter «E» or the earth symbol Energy Saving Advice or coloured green and yellow.

2.Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter «N» or coloured black.

3.Connect the brown (live) wire to the terminal in the plug which is marked with the letter «L» or coloured red.

4.Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.The plug moulded onto the lead incorporates a fuse. For replacement, use a 13amp BSI362 fuse. Only ASTA or BSI approved fuses should be used.

The plug must not be used if the fuse cover/carrier is lost.The cover/carrier is indicated by the coloured insert at the base of the plug.

A replacement cover/carrier must be obtained from your local Service Force Centre.

Food Storage

To obtain the best results from your appliance, neither hot foods nor liquids which may evaporate, should be placed in the larder compartment.

Keep the time between buying chilled food and placing it in your fridge as short as possible.

Do not push food together too much, try to allow air to circulate around each item.

Do not store food uncovered.

Remove suspect food from your refrigerator and clean, refer to ‘Maintenance and Cleaning’.

Energy Saving Advice

Do not install the cabinet close to sources of heat, i.e. boiler or radiator.

Locate the appliance in a cool well ventilated room and make sure that the air openings of the cabinet are not obstructed.

Always leave warm food to cool down to room temperature before placing in the fridge.

Try to avoid keeping the door open for long periods, or opening the door too frequently as warm air will enter the cabinet, and cause the compressor to switch on unnecessarily often.

Ensure there are no obstructions preventing the door from closing properly.

It is advisable to peridocally clean the refrigeration system at the back of the appliance with a duster or vacuum cleaner.

6

15

Page 6
Image 6
John Lewis JLBILIC02 Hints and Tips, Installation, Technical Data, Heating elements rating, Air recycling, Food Storage