17
Adjusting the level of conductivity
Water contains, a variable quantity of limestone and
mineral salts of which quantities vary according to
geographical locations thus varying its conductivity values.
Relevant variations of the conductivity of the water
compared to those prefixed by the factory could slightly
influence the residual humidity of the laundry at the end
of the cycle.
Your dryer allows you to regulate the sensitivity of the
drying sensor based on conductivity values of the water
by using the following procedure.
To establish the hardness of your water to correspond
with the table opposite please contact your local water
authority.

Procedure:

Turn the programme selector dial to switch on the
appliance
In selection mode press simultaneously the buttons 3and
6until «C0» appears on the digits.

Adjusting the level of conductivity:

Press the button 5 sequentially: the level of conductivity is
indicated by the lighting of the horizontal hyphens.
Normally, the appliance is factory-set to the
12345 6
Delay
startDoor Quick
Start/
Pause
Drying
Cooling
End
Filter
Full tank
Condenser
Dry time
JLTDCO5
Half
power
Alarm
off
12345 6
1.25
Delay
startDoor Quick
Start/
Pause
Drying
Cooling
End
Filter
Full tank
Condenser
Dry time
JLTDCO5
Half
power
Alarm
off
Iron dry
Delicates
Synthetics
60 minutes
Extra dry
Off
Store dry
Cupboard dry
Damp dry
Iron dry
Machine iron dry
Extra dry
Cupboard dry
90 minutes
30 minutes
Cottons
Dry cleaning
Cooling 10 minutes
highest level; however, certain models may be
configured differently.

Memorising the new setting:

Simultaneously press down the buttons 3and 6until the
previous drying cycle time appears again on the display
and the buzzer sounds.
Display Conductivity
degree
Approximative
value (µS/cm)

CC00Low < 300

CC00Medium 300 - 600

CC00High > 600

125980753.qxp 2005-12-05 08:01 Page 17