Toshiba RAV-SP454AT-E 159, Compressor 1. Removal of broken compressor, Part name Procedure

No. Part name Procedure Remarks

6Compressor 1. Removal of broken compressor

Compressor lead	1)	Recover the refrigerant gas.	Piping panel (Rear)
	2)	Carry out works of 1 of 1 and	2 , 3 .

3) Remove the piping panel (Front).

Remove screws of the piping panel
(Front) and the bottom plate.
(Hexagonal screw Ø4 × 10, 2 pcs.)	Piping panel (Front)
Remove screws of the piping panel
(Front) and the piping panel (Rear).	Bundling band	Pipe cover
(Hexagonal screw Ø4 × 10, 1 pc.)
	for heat proof

4) Remove the piping panel (Rear).

Remove screws of the piping panel		TD sensor
(Rear) and the bottom plate.
(Hexagonal screw Ø4 × 10, 2 pcs.)
5) Remove the valve fixing plate.
Remove bolts of the valve.
(Hexagonal screw Ø6 × 15, 4 pcs.)		Compressor
Remove screws of the valve fixing plate		lead
and the partition plate.
(ST1T Ø4 × 8, 1 pc.)					Compressor
Remove screws of the valve fixing plate					case thermo
and the accumulator.
(ST1T Ø4 × 8, 1 pc.)		TS sensor		Pipe cover,
Cut off the bundling band for the dis-
				bundling band
charge pipe and the suction pipe and
then remove each sensor and coil lead
of PMV.
6) Remove the sound insulating plate.		Suction pipe
(Upper side, outer winding, inner winding)		Accumulator		Discharge pipe
7) Remove terminal cover from the
compressor and then remove the
compressor lead and also the
compressor case thermo.
8) Remove TD sensor fixed to the
discharge pipe.
9) Remove the compressor lead.			Pipe cover, bundling band,
(Leave the ferrite core attached to the			each sensor (TL, TO, TE, TD, TS sensors)
			PMV coil lead
electric parts box as it is.)		Black pipe cover for heat proof,
		bundling band for heat proof,
Control P.C. board		each sensor (TL, TO, TE, TD, TS sensors)
		PMV coil lead
U : CN200	Red
V : CN201	White
W : CN202	Black	Control
(Tightening torque: 1.47 ± 0.1N•m)		P.C. board			Compressor
					lead

Compressor lead

Ferrite core

– 159 –