Toshiba RAV-SM454SDT-E, RAV-SP804AT-E Procedure, Remarks, Compressor, Screws 2 pcs, support board

No.	Part name	Procedure	Remarks
7	Compressor	1) Perform works of items 1 of 1 and 2	,
		3 , 4 , 5 .	Partition plate

2)Discharge refrigerant gas.

3)Remove the partition plate.

(ST1T Ø4 × 8L, 3 pcs.)

4)Remove the noise-insulator.

5)Remove the terminal covers of the compressor, and disconnect lead wires of the compressor and the compressor thermo assembly from the terminal.

6)Remove pipes connected to the compressor with a burner.

				Compressor
				lead
		CAUTION
	Pay attention to that flame does not			Case thermo
	involve 4-way valve or PMV. (If doing
	so, a malfunction may be caused.)
7) Take off the fixing screws of the bottom
	plate and heat exchanger.			Heat exchanger
	(ST1T Ø4 × 8L)
8) Take off the fixing screws of the valve			Remove
	clamping plate to the bottom plate.		(Discharge pipe)
	(ST1T Ø4 × 8L, 2 pcs.)
9) Pull upward he refrigerating cycle.			Remove	Screw
10) Take off nut fixing the compressor to			(Suction pipe)
	the bottom place.			Valve
				support board
				Screws (2 pcs.)
		CAUTION
				Compressor bolt (3 pcs.)

When reconnecting the lead wires to the compressor terminals after replacement of the compressor, be sure to caulk the Faston terminal without loosening.

8 Reactor	1)	Perform works of item 1 of 1 and 3 .
	2)	First take off two screws		Partition	Reactor
		(ST1T Ø4 × 8L) of the reactor fixed to	Reactor	plate
					support board
		the reactor support.

3) Remove the reactor support from the partition plate. (ST1T Ø4 × 8L, 4 pcs.)

4) Take off two screws (ST1T Ø4 × 8L) directly attached to the partition plate.

– 152 –