Toshiba RAV-SM564SDT-E Change of lighting time of filter sign, To secure better effect of heating

nChange of lighting time of filter sign

According to the installation condition, the lighting time of the filter sign (Notification of filter clean- ing) can be changed.

Follow to the basic operation procedure

(1 → 2 → 3 → 4 → 5 → 6 ).

•For the CODE No. in Procedure 3, specify [01].

•For the [Set data] in Procedure 4, select the setup data of filter sign lighting time from the following table.

Setup data	Filter sign lighting time
0000	None
0001	150H
0002	2500H (At shipment from factory)
0003	5000H
0004	10000H

nTo secure better effect of heating

When it is difficult to obtain satisfactory heating due to installation place of the indoor unit or structure of the room, the detection temperature of heating can be raised.

Also use a circulator, etc. to circulate heat air near the ceiling.

Follow to the basic operation procedure

(1 → 2 → 3 → 4 → 5 → 6 ).

•For the CODE No. in Procedure 3, specify [06].

•For the set data in Procedure 4, select the setup data of shift value of detection tempera- ture to be set up from the table below.

Setup data	Detection temp shift value
0000	No shift
0001	+1°C
0002	+2°C (At shipment from factory)
0003	+3°C
0004	+4°C
0005	+5°C
0006	+6°C

nHow to set up power saving mode

SAVE

1.Push button for at least four seconds when the air conditioner is not working.

flashes. Indicates CODE No. “C2.”

2.Select an indoor unit to be set by pushing UNIT LOUVER (left side of the button).

Each time you push the button, unit numbers change as follows:

Unit No.	Unit No.	Unit No.
1-1	1-2	1-3

Unit No.

1-4

The fan of the selected unit runs.

3.Adjust the power save setting by pushing TIME / buttons. Each push of the button changes the power level by 1% within the range from 100% to 50%.

* The factory setting is 75%.

•This indication may not be true for types other than 4-series outdoor unit.

Setting of power level in power saving mode

4.Determine the setting by pushing SET button.

5.Push TEST button to complete the setting.

– 125 –