Toshiba RAV-SP454ATZG-E, RAV-SP804ATZG-E, RAV-SP804ATZ-E 161, Compressor 2. Mounting of compressor

No. Part name Procedure Remarks

6Compressor 2. Mounting of compressor

Compressor lead	1) Mount the compressor in the reverse	Compressor lead	Wind the ferrite core
(Continued)			with the compressor
	procedure of removal.		lead wire by 4 times.

NOTES:				Ferrite core
∗	After exchange of the compressor, be sure to
	exchange the compressor lead. (Repair part	0 to 50
	code of compressor lead: 43160591)
		(Positioning
	In this time, wrap the ferrite core with the	standard of
		compressor
	compressor lead wire by 4 times.	lead wire)
	Using bundling band on the market, bind the
	compressor lead. As the compressor lead is	Using the bundling band on the market,
	long, be sure that the compressor lead does	fix the bundle at 2 positions.
	not contact with the discharge pipe.	Pass the soundproof plate (outer winding)
∗	Fix the removed each sensor and PMV coil	through between the suction pipe and
	lead wire to the discharge pipe and the	the accumulator.
				Suction pipe
	suction pipe with the bundling band via the
		Accumulator
	pipe cover.
	In this time, take note that each sensor and	Discharge pipe
	PMV coil lead wire do not come to contact
	with the discharge pipe and the reactor.	Header pipe
	(For fixing to the discharge pipe, use the
	black heat-proof pipe cover and the bundling
	band for heat-proof which is sold on the
	market.)
∗	As shown in the right figure, mount the
	soundproof plate (inner winding, outer
	winding) by inserting between the compres-
	sor and the piping, and between piping and	Pass the soundproof plate
	the partition plate.
		(inner winding) through
∗	Put the compressor lead wire and the	between compressor and
		discharge pipe, suction pipe
	compressor case thermo between inner	and then put it on the other
	winding and outer winding of the soundproof	side at this position.
			Put the soundproof plate
	as if dropping them in.
			(outer winding) on the
			other side at this position.
			Soundproof plate
			(upper)
	Pipe cover, bundling band, TS sensor

Discharge pipe

Soundproof plate (outer winding)

Do not make clearance between the soundproof plate (upper) and the soundproof plate (outer winding).

Black heat-proof pipe cover and heat-proof bundling band,

each sensor (TL, TO, TE, TD, TS sensor) PMV coil lead wire

Set each sensor so that it does not come to contact with the discharge pipe.

Suction pipe PMV coil lead

Pipe cover, bundling band,

each sensor (TL, TO, TE, TS sensor) PMV coil lead

– 161 –