Toshiba RAV-SP804ATZG-E 1 2 END, 1 2 3 END, Confirmation of Indoor Unit No. Position, Procedure

UNIT LOUVER

13-5. Confirmation of Indoor Unit No. Position

1. To know the indoor unit addresses though position of the indoor unit body is recognized

•In case of individual operation (Wired remote controller : indoor unit = 1 : 1) (Follow to the procedure during operation)

<Procedure>

1	Push ON / OFF	button if the unit stops.
2	Push UNIT LOUVER	button.
	Unit No. 1-1is displayed on LCD.

(It disappears after several seconds.)

The displayed unit No. indicate line address and indoor unit address.

(When other indoor units are connected to the identical remote controller (Group control unit), other unit numbers are also displayed every pushing

UNIT LOUVER button.

TEMP.			ON / OFF
	TIMER SET	FAN	MODE
	TIME	SAVE	VENT
FILTER	SET CL	SWING/FIX	UNIT LOUVER
RESET TEST

1

Operation

2

<Operation procedure>

1 2 END

2.To know the position of indoor unit body by address

•To confirm the unit No. in the group control

(Follow to the procedure during operation) (in this procedure, the indoor units in group control stop.)

<Procedure>

The indoor unit numbers in the group control are successively displayed, and fan, louver, and drain pump of the corresponding indoor unit are turned on.

(Follow to the procedure during operation)

1 Push VENT and TEST buttons simultaneously for

4 seconds or more.

•Unit No. is displayed.

•Fans and louvers of all the indoor units in the group control operate.

2 Every pushing button, the unit numbers in the group control are successively dis- played.

1

3

TEMP.			ON / OFF
	TIMER SET	FAN	MODE
	TIME	SAVE	VENT
FILTER	SET CL	SWING/FIX	UNIT LOUVER
RESET TEST

2

•The unit No. displayed at the first time indicates the master unit address.

•Fan and louver of the selected indoor unit only operate.

3 Push TEST button to finish the procedure.

All the indoor units in the group control stop.

<Operation procedure>

1 2 3 END

– 140 –