Toshiba RAV-SP404ATZ-E, RAV-SP804ATZG-E Changing of settings of for applicable controls, 123

4. When installing separately sold filters

REQUIREMENT

•When you use this air conditioner for the first time, it takes approx. 5 minutes until the remote controller becomes available after power-on. This is normal.

<When power is turned on for the first time after installation>

It takes approx. 5 minutes until the remote controller
becomes available.	Power ON	“SETTING”
		flashes

<When power is turned on for the second (or later) time>

It takes approx. 1 minute until the remote controller
becomes available.	Power ON	“SETTING”
		flashes

Approx. 5 minutes

“SETTING”	Remote
	controller
goes out
	is available

Approx. 1 minute

“SETTING”	Remote
	controller
goes out
	is available

•Normal settings were made when the indoor unit

was shipped from factory. Change the indoor unit settings as required.

•Use the wired remote controller to change the settings.

∗The settings cannot be changed using the wireless remote controller, sub remote controller, or remote- controllerless system (for central remote controller only).

Therefore, install the wired remote controller to change the settings.

n Changing of settings of for applicable controls

Basic procedure for changing settings

Change the settings while the air conditioner is not working. (Be sure to stop the air conditioner before making settings.)

Procedure 1

Push TEST button and temp. setup	/	button
simultaneously for at least 4 seconds.

After a while, the display flashes as shown in the figure. Confirm that the CODE No. is [01].

4	1
	3
5
6	2
1

•If the CODE No. is not [01], push TEST button to erase the display content, and repeat the procedure from the beginning.

(No operation of the remote controller is accepted for a while after TEST button is pushed.)

(∗ Display content varies with the indoor unit model.)

Procedure 2

UNIT LOUVER

Each time you push button, indoor unit numbers in the control group change cyclically. Select the indoor unit you want to change settings for.

The fan of the selected unit runs. You can confirm the indoor unit for which you want to change settings.

∗∗∗∗∗ -∗ ∗∗

Procedure 3

Using temp. setup		/	buttons, specify CODE
No. [∗∗	].

Procedure 4

Using timer time		/	buttons, select SET DATA
[∗∗∗∗	].

Procedure 5

Push SET button. When the display changes from flashing to lit, the setup is completed.

•To change settings of another indoor unit, repeat from Procedure 2.

•To change other settings of the selected indoor unit,

repeat from Procedure 3.

Use SET button to clear the settings.

To make settings after SET button was pushed, repeat from Procedure 2.

Procedure 6

When settings have been completed, push TEST button to determine the settings.

When TEST button is pushed, “SETTING” flashes and then the display content disappears and the air conditioner enters the normal stop mode.

(While “SETTING” is flashing, no operation of the remote controller is accepted.)

– 123 –