Toshiba RAV-SP804AT-E, RAV-SP454AT-E 142, Detachment, Attachment, No. Part name Procedure Remarks

14. DETACHMENTS

14-1. Indoor Unit

14-1-1. Slim Duct Type

RAV-SM404SDT-E, RAV-SM454SDT-E, RAV-SM564SDT-E

No. Part name Procedure Remarks

REQUIREMENT

Be sure to put on gloves at working; otherwise an injury may be caused by parts, etc.

•Before replacement of the parts, be sure to stop operation of the air conditioner and turn off switch of the breaker.

1 Air Filter	1. Detachment	[In case of sucking system from rear side]
	1) Push knobs (3 positions) of the air filter hooks	Air filter
	toward the arrow direction to remove the air
		Push
	filter.

2. Attachment
1) Insert the air filter surely into the hooking
grooves (4 positions) at the opposite side of the
hooks, and then fix it to the original position.	Hook
NOTE)
In case of sucking system from bottom side,	[In case of sucking system from bottom side]
installation direction is determined. Install the air
filter so that hooks are aligned at discharge side.	Air filter

			Hook	Push
2 Plate inlet-A 1. Detachment			[In case of sucking system from rear side]
Plate inlet-B
	1)	Take off fixing screws while holding the plate
		inlet-A with hands to remove it.		Plate inlet-B: 6 screws
		(Sucking system from rear side: Ø4 × 10, 8 pcs)
		(Sucking system from bottom side:
		Ø4 × 10, 11 pcs)
	2)	Take off fixing screws while holding the plate
		inlet-B with hands to remove it.
		(Ø4 × 10, 6 pcs)
	NOTE)		Plate inlet-A: 8 screws
	Be careful that sheeting metal does not fall when		[In case of sucking system from bottom side]
	removing the plate inlet.
				Plate inlet-A: 11 screws

2. Attachment

1)Using the screws taken off in procedure 1. 2) of 2 , attach the plate inlets in order of B

→ A while holding them not to fall down.

Plate inlet-B: 6 screws

– 142 –