Toshiba RAV-SM454SDT-E, RAV-SP804ATZG-E, RAV-SP804ATZ-E Restriction ratio can be set by keeping

No.	Item		Outline of specifications	Remarks
18	DC motor	1)	When the fan operation has started, positioning of the stator
			and the rotor are performed.
			(Moves slightly with tap sound)
		2)	The motor operates according to the command from the
			indoor controller.

Notes)

•When the fan rotates while the air conditioner stops due to entering of outside air, etc, the air conditioner may operate while the fan motor stops.

		• When a fan lock is found, the air conditioner stops, and an error							Check code [P12]
		is displayed.
19	Save operation	1)	Turn on SAVE	button on the remote controller.					Operation and display
		2)	During operation of save operation,		SAVE	lights on the wired			also are unavailable
									on the wired remote
			remote controller.
									controller RBC-
		3)	During save operation, the current release control is performed
									AMT31E and before.
			with the restriction ratio set in EEPROM on the outdoor unit.
									Carry out setting
		4)	The restriction ratio can be set by keeping			SAVE	button
									operation during stop
			pushed for 4 seconds or more on the remote controller.
									of the unit; otherwise
		5)	When validating the save operation, the next operation starts
									the unit stops
			with save operation valid because contents are held even						operation.
			when operation stops, operation mode changes or power						For the setup opera-
			supply is reset.
									tion, refer to “How to
		6)	The restriction ratio can be set by changing the setup data of
									set up contents of
			Item code (DN) [C2] in the range of 50 to 100%						save operation” of
			(every 1%, Setting at shipment: 75%).						Installation Manual.
20	8°C heating/	1)	This functional is intended for the cold latitudes and performs
	Frost protective		objective heating operation (8°C heating operation).
	operation	2)	This function is valid only for combination with the outdoor						In a group connection,
			units (Super Digital Inverter (SDI) 4-series outdoor units).						if there is even one
		3)	Using the indoor DN code [D1] (1 bit), Valid/Invalid of this						combination with other
									unit, “This function is
			function is set up at the customer’s side.
									not provided.” is
			∗ The setup by DN code is Invalid [0]/Valid [1] and Invalid [0]
									displayed.
			has been set at the shipment.
		4)	This operation is the heating operation which sets 8°C as the
			setup temperature of the target.
		5)	This function starts operation by pushing temperature button						The setup tempera-
			during heating operation; besides by pushing					button	ture jumps from [18]
			for 4 seconds or more after temperature reached the minimum						to [8].
			set temperature.
		6)	To stop/release this operation, select and execute one from
			the following operations.
			Q Push	button: Heating operation (18°C setting) continues.
			R Push [START/STOP] button: Air conditioner stops.
			(Heating 18°C operation at the next start)

MODE

SPush : Other operation mode is selected and the operation continues.

7)As the setup temperature is 8°C and the human heating is not targeted, the cold air discharge preventive control (Item 7) is made invalid to suppress the intermittent operation.

8)The settings of the air direction and air volume are changeable during this operation.

9)The indoor fan stops to protect the compressor for 2 minutes after start of heating operation (Thermo-ON) by this function.

– 54 –