Hearth and Home Technologies GBST4336I 1 A C, Log Placement, Log Set Assembly LOGS-2129

F. Install the Log Assembly	LOG PLACEMENT
Log Set Assembly: LOGS-2129	INSTRUCTIONS

Models: GDST4336I, GDFL4136I, GDCL4136I, GDCR4136I,

GBST4336I, GBFL4136I

CAUTION: DO NOT reposition logs that have been factory installed! Follow these instructions to position the logs that were packaged separately.

3 2 1

Log Set Components

D

A PILOT

BC

Figure 1. Log Assembly Location Figure 2. Factory Installed Logs and Pilot Position

CAUTION! Logs are fragile! Carefully remove the logs and cardboard tray from the inside of the fireplace. See Figure Remove the microfoam and inspect the logs for damage. Inspect the four factory installed logs for damage. Locate the pilot in order to verify your position in relation to the appliance. See Figure 2.

Models: GDST4336I, GDFL4136I, GDCL4136I, GBST4336I, GBFL4136I

(For Model GDCR4136I, see next page.)

PILOT

1

A

PILOT

B HUMP1

1 A

C

Figure 3. Placement of Log #1 Figure 4. Placement of Log #1

STEP 1. Log #1 (SRV2129-704):Place Log #1 on Log A. The end and bottom of Log #1 fit into the indentation on Log A highlighted in Figure 3. The Y-shaped end of Log #1 will rest on the smooth area of Log B as shown in Figure 4.

2129-935

Heatilator • GBST4336I, GBFL4136I • 2135-900 Rev. D • 11/08 37