9 Appliance Preparation
A.Installing Outside Air Kit Damper Assem- bly
CAUTION! Risk of Cuts/Abrasions/Flying Debris. Wear protective gloves and safety glasses during instal- lation. Sheet metal edges are sharp.
WARNING! Risk of Fire/Asphyxiation. DO NOT draw out-
side combustion air from:
•Wall, floor or ceiling cavity.
•Enclosed space such as an attic or garage.
•Close proximity to exhaust vents or chimneys. Fumes or odor may result.
•Remove and discard cover plate or knockout from side of appliance.
•Open air kit damper slightly.
•Locate door hinge toward back of appliance (see Figure 9.1).
DOOR |
HINGE |
HANDLE |
Figure 9.1 Damper Assembly and Handle |
Figure 9.2 | Outside Air Kit Installation |
B. Gas and Electrical Connections
If applicable, ensure that gas and electrical connections are installed at this time. Refer to Sections 11 and 12.
•Attach damper assembly to appliance using screws provided (see Figure 9.2).
•Insert narrow end of handle through tab and into upper slot of door.
•Check handle operation. Pull handle out to open, and in to close.
Heatilator • GBST4336I, GBFL4136I • | 25 |