Unpacking
It is recommended to deliver the appliance in original packaging, in vertical position considering the
protective warning on packaging.
After positioning, the appliance must not be switched on for approx. 2 hours to allow the refrigerant to settle.
Unpack the appliance and check if there are damages on it. Report any damage immediately to the place where you bought it. In this case retain packaging.
Cleaning
Remove all adhesive tape and packaging, which ensure the accessories do not move in the appliance.
Wash the inside of the appliance using lukewarm water and bicarbonate of soda (5ml to 0.5 litre of water).
After cleaning dry the inside of the appliance thoroughly.
Location
The appliance should be placed in a well ventilated, dry room.
The appliance energy use is affected by the ambient temperature.
The appliance should therefore:
not be installed next to radiators, cookers or other sources of heat
only be installed at a location where the ambient temperature corresponds to the climate classification, for which the appliance is designed.
Climate Classification
The climate classification can be found on the rating plate located inside the appliance.
The following table shows the ambient temperature for each climate classification:
Climate Classification | Ambient Temperature |
|
|
SN | +10 to +32 °C |
N | +16 to +32 °C |
ST | +18 to +38 °C |
Ventilation Requirements
The appliance must have adequate ventilation to ensure correct operation.
Diagram shows the ventilation requirements when installed:
A:Under a worktop, or cupboard.
The clearance space of 10 cm above the appliance may be reduced to 5 cm providing a clearance space 2,5 cm is left on either side of the appliance.
B:When freestanding
Levelling |
The appliance must be level. Level the appliance by adjusting the two adjustable feet (1) at the front of the appliance.
If required the washer (2) can be removed.
2 |
1 |
7
