4.Screw the hose back onto the tap.
5.Unscrew the hose from the machine. Keep a rug nearby because some water may flow.
6.Clean the filter in the valve with a stiff brush or with the piece of cloth.
7.Screw the hose back to the machine and make sure the connection is tight.
8.Turn on the water tap.
Emergency emptying out
If the water is not discharged, proceed as follows to empty out the machine:
1.pull out the plug from the power socket;
2.close the water tap;
3.if necessary, wait until the water has cooled down;
4.open the pump door;
5.place a bowl on the floor. Remove the emergency emptying cap from the filter. The water should drain by gravity into the bowl. When the bowl is full, refit the cap into the filter. Empty the bowl. Repeat the procedure until water stops flowing out;
6.clean the pump if necessary as previously described;
7.screw the pump again and close the door.
Frost precautions
If the machine is installed in a place where the temperature could drop below 0°C, proceed as follows:
1.Pull out the plug from the power socket.
2.Turn off the water tap.
3.Unscrew the inlet hose.
4.Place the end of the inlet hose in a bowl placed on the floor, open the emergency emptying cup of the filter and let water drain out.
5.Refit the emergency emptying cap into the filter and screw the water inlet hose back.
6.When you intend to start the machine up again, make sure that the room temperature is above 0°C.
31
