Jonsered BC2043, BC2053 manual B L C M A, Assembling the cutting equipment, G E F D B C, Assembly

ASSEMBLY

9Lap and fix the stop switch wires and connectors with clamp (I).

I

10 Refit the air filter cover.

Assembling the cutting equipment

WARNING! When fitting the cutting

!attachment it is extremely important that the raised section on the drive disc/support flange engages correctly in the centre hole of the cutting attachment. If the cutting attachment is fitted incorrectly it can result in serious and/or fatal personal injury.

WARNING! Never use a cutting attachment

!without an approved guard. See the chapter on Technical data. If an incorrect or faulty guard is fitted this can cause serious personal injury.

IMPORTANT! If a saw blade or grass blade are to be used the machine must be equipped with the correct handlebar, blade guard and harness.

Fitting the cord cutter and guard extension to the trimmer guard

•Attach the cord cutter to the guard extension with screw and washer as shown.

•Fit the guard extension to the trimmer guard as shown.

Fitting a blade guard, grass blade and grass cutter

•Fit the guard (A) to the gear housing using the support plate (M) and two screws (L).

BL C M

A

•Fit the drive disc (B) on the output shaft.

•Turn the blade shaft until one of the holes in the drive disc aligns with the corresponding hole in the gear housing.

•Insert the locking pin (C) in the hole to lock the shaft.

•Place the blade (D), support cup (E) and support flange

(F) on the output shaft.

G

E

F

D

B

C

•Fit the nut (G). The nut must be tightened to a torque of 35-50 Nm (3.5-5 kpm). Use the socket spanner in the tool kit. Hold the shaft of the spanner as close to the blade guard as possible. To tighten the nut, turn the spanner in the opposite direction to the direction of rotation (Caution! left-hand thread).

12 – English