SAFETY INSTRUCTIONS
•We recommend that you use our raker gauge to achieve the correct clearance and bevel on the raker lip.
WARNING! The risk of kickback is increased
!if the raker clearance is too large!
Setting the raker clearance
•Before setting the raker clearance the cutting teeth should be newly sharpened. We recommend that you adjust the raker clearance every third time you sharpen the chain.
NOTE! This recommendation assumes that the length of the cutting teeth is not reduced excessively.
•To adjust the raker clearance you will need a flat file and a raker gauge.
•Place the gauge over the raker lip.
•Place the file over the part of the lip that protrudes through the gauge and file off the excess. The clearance is correct when you no longer feel any resistance as you draw the file over the gauge.
Tensioning the chain
WARNING! A slack chain may jump off and
!cause serious or even fatal injury.
The more you use a chain the longer it becomes. It is therefore important to adjust the chain regularly to take up the slack.
Check the chain tension every time you refuel. NOTE! A new chain has a
The position of the chain tensioning screw on our chain saws varies from model to model. See the What is what? section to find out where it is on your model.
Tension the chain as tightly as possible, but not so tight that you cannot pull it round freely by hand.
•Undo the bar nuts that hold the clutch cover/chain brake. Use the combination spanner. Then tighten the bar nuts by hand as tight as you can.
•Raise the tip of the bar and stretch the chain by tightening the chain tensioning screw using the combination spanner. Tighten the chain until it does not sag from the underside of the bar.
•Use the combination spanner to tighten the bar nuts while lifting the tip of the bar at the same time. Check that you can pull the chain round freely by hand and that it does not sag from the underside of the bar.
Lubricating cutting equipment
WARNING! Poor lubrication of cutting
!equipment may cause the chain to snap, which could lead to serious, even fatal injuries.
Chain oil
Chain oil must demonstrate good adhesion to the chain and also maintain its flow characteristics regardless of whether it is warm summer or cold winter weather.
As a chain saw manufacturer we have developed an optimal chain oil which has a vegetable oil base. We recommend the use of our own oil for both maximum chain life and to minimise environmental damage. If our own chain oil is not available, standard chain oil is recommended.
In areas where oil specifically for lubrication of saw chains is unavailable, ordinary EP 90 transmission oil may be used.
Never use waste oil! This is dangerous for yourself, the machine and the environment.
English – 13
