Turbo Air Cleaning centrifugal cleaning | Jonsered CS 2245 specification

MAINTENANCE

”Turbo Air Cleaning” centrifugal cleaning

Centrifugal cleaning means the following: All air to the carburetor passes through the starter. Dirt and dust is pushed out by the cooling fan.

IMPORTANT! In order to maintain operation of the centrifugal cleaning system it must be regularly maintained. Clean the air intake to the starter, the ﬁns on the ﬂywheel, the space around the ﬂywheel, inlet pipe and carburetor compartment.

Winter use

Running problems can occur when using the machine in the cold and snowy conditions caused by:

•Too low engine temperature.

•Icing of the air ﬁlter and carburetor. Special measures are therefore often required:

•Partly mask the air inlet on the starter to increase the working temperature of the engine.

Temperature -5°C (23°F) or colder:

For running the machine in cold weather or powder snow, a special cover is available, which is mounted on the starter housing. This reduces the intake of cold air and prevents large amounts of snow from being sucked in.

CAUTION! If the special winterising kit has been ﬁtted or any measures have been taken to increase the temperature these changes must be reversed before the machine is used in normal temperature conditions. Otherwise there is a risk of overheating, resulting in severe damage to the engine.

IMPORTANT! Any maintenance other than that described in this manual must be carried out by your servicing dealer (retailer).

English – 37

Image 37

Jonsered CS 2245S, CS 2250S manual Turbo Air Cleaning centrifugal cleaning, Winter use, Temperature -5C 23F or colder

Contents

CS 2245S Symbols on the machine KEY to SymbolsSymbols in the operator’s manual You will ﬁnd the following labels on your chain saw Contents Dear customer Introduction What is what on the chain saw? What is WHAT? Before using a new chain saw General Safety Precautions Always use common sense Machine′s safety equipmentPersonal protective equipment Chain brake and front hand guard General Safety Precautions Chain catcher Throttle lockoutRight hand guard Cutting equipment Stop switchVibration damping system Mufﬂer Bar Cutting equipment designed to reduce kickbackChain General information on sharpening cutting teeth Sharpening your chain and adjusting depth gauge setting Tensioning the chain CS 2245S, CS 2250S Lubricating cutting equipment Checking chain lubrication Filling with chain oilChain drive sprocket Checking wear on cutting equipment Needle bearing lubrication Fitting the bar and chain AssemblyWorking with the chain Assembly Fuel Fuel Handling Fueling Fuel safetyTransport and storage Long-term storage Starting and stopping Starting and StoppingStarting Warm engine Stopping Working Techniques Basic safety rulesBefore use General working instructions General rules Terms Basic cutting technique Limbing Tree felling techniqueLog is supported at one end. There is a high risk Safe distance Clearing the trunk and preparing your retreat Felling directionDirectional cuts Felling cut What is kickback? How to avoid kickbackFreeing a tree that has fallen badly Cutting the trunk into logs Carburetor adjustment MaintenanceGeneral Checking the inertia brake release Mufﬂer Replacing the starter cord StarterTensioning the recoil spring Replacing the return and drive springs Air ﬁlterFitting the starter Lubricating the bar tip sprocket Spark plugNeedle bearing lubrication Cooling system Temperature -5C 23F or colder Turbo Air Cleaning centrifugal cleaningWinter use Daily maintenance Weekly maintenance Monthly maintenance Maintenance schedule Technical data Technical Data 050/1,3 mm Bar and chain combinations058/1,5 mm Saw chain ﬁling and ﬁle gauges Repair or Replacement of Parts Repair or Federal Emission Control Warranty Statement Safety precautions for chain saw users American Standard Safety PrecautionsKickback safety precautions Other safety precautions 1151012-95