ASSEMBLY
Assembling other guards and cutting equipment
Adjusting the harness and clearing saw
•Fit the appropriate guard (A) for use with the trimmer head. Hook the guard onto the shaft fitting and secure it with the bolt (L).
•Fit the disc drive (B) on the output axle.
•Turn the blade axle until one of the disc drive’s holes aligns with the corresponding hole in the gear housing.
•Insert the locking pin
(C) into the hole to lock the axle.
•Screw on the trimmer head (H) in the direction of rotation.
•Dismantling takes place in the reverse order.
H |
!WARNING!
When working with the clearing saw it should always be hooked in the harness. If this is not done, you cannot control the clearing saw safely and this can result in injury to yourself or someone else. Never use a harness with a defective quick release catch.
Quick release
On the front is an easily accessible, quick release catch. Use this if the engine should catch fire or in any other emergency situation when you quickly need to take off the harness and machine.
Even load on the shoulders
A
Correct height
Adjust the support strap so that the cutting attachment is parallel to the ground.
Correct balance The cutting attachment should rest lightly on the ground. If you use a saw blade it should balance about 10 cm above the ground to prevent contact with stones and the like. Adjust the position of the support strap attachment ring to balance the clearing saw correctly.
English – 19
