ASSEMBLY
Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard wrench sizes are listed.
(1) | 3/4" wrench | Pliers |
(2) | 7/16" wrenches | Tire pressure gauge |
(1) | 5/16" wrench |
|
(1) | 1/2" wrench | Utility knife |
When right or left hand is mentioned in this manual, it means when you are in the operating position (seated behind the steering wheel).
TO REMOVE TRACTOR FROM CARTON
UNPACK CARTON
•Remove all accessible loose parts and parts cartons from carton.
•Cut along dashed lines on all four panels of carton. Remove end panels and lay side panels flat.
•Check for any additional loose parts or cartons and remove.
BEFORE REMOVING TRACTOR FROM SKID
TO INSTALL STEERING WHEEL (See Fig. 1)
INSTALL STEERING WHEEL
•Position front wheels of the tractor so they are pointing straight forward.
•Remove steering wheel adapter from steering wheel and slide adapter onto steering shaft extension.
•Position steering wheel so cross bars are horizontal (left to right) and slide inside boot and onto adapter.
•Assemble large flat washer, lock washer, hex bolt and tighten securely.
•Snap steering wheel insert into center of steering wheel.
•Remove protective materials from tractor hood and grill.
IMPORTANT: CHECK FOR AND REMOVE ANY STAPLES IN SKID THAT MAY PUNCTURE TIRES WHERE TRACTOR IS TO ROLL OFF SKID.
INSTALL SEAT (See Figs. 2 and 3)
•Remove bolt and flat washer securing seat to cardboard packing and set aside for assembly of seat to tractor. Remove the cardboard packing and discard.
•Connect switch to seat.
•Place seat on seat pan so all three (3) bottom pads are positioned over large slotted holes in pan.
ASSEMBLE EXTENSION SHAFT AND BOOT |
| |
• Slide extension shaft onto lower steering shaft. | SEAT | |
• Place tabs of steering boot over tab slots in dash and | ||
SWITCH | ||
push down to secure. | ||
| ||
INSERT | PAD | |
| ||
HEX BOLT |
| |
LOCK WASHER | SLOT | |
LARGE FLAT | SEAT | |
WASHER | ||
| PAN | |
STEERING |
| |
WHEEL | TAPE | |
| ||
| WIRING HARNESS | |
STEERING BOOT |
| |
| Fig. 2 |
ADAPTER |
•Push down on seat to engage pads in slots and pull seat towards rear of tractor.
EXTENSION SHAFT
LOWER
STEERING
SHAFT
•Raise seat and tighten bolt securely.
•Remove tape and discard.
•Lower seat into operating position and sit on seat. Press clutch/brake pedal all the way down. If operating position is not comfortable, adjust seat.
To adjust seat: Grasp adjustment handle and pull up, slide seat to desired position and release adjustment handle.
Fig. 1 | 6 |