3.Lay the Bed (8) on the ground inside of the assembled frame. Make sure that the two warn- ing decals (not shown) are on top of the Bed.
Note: There are V-rings around the edge of the Bed (8) and holes around the top of the frame. During this step, you will attach the Bed to the frame using the included Springs (10) for holes on top of frame and for holes on bottom of frame (see the inset drawing). Hook a spring to the Bed(8) and using the spring pulling tool(22), pull the spring from the Bed to the hole slot in the trampoline frame with even spring tension.
Be careful where you place your hands, the Springs and frame joints can pinch.
To attach each Spring, you will rst hook one end of the Spring into a V-ring with black webbing with yelow line location (see the inset drawing).
No yellow line
Black webbing with yellow line
Hook the rst two Spring(10) into two the V-rings (black webbing with yellow line) on the Bed(8) and into the holes on the top tube. Attach two more Springs (10) with black with yellow line location directly across the Bed (with the webbing) from the rst two Spring. Attach two more Spring(10) with black webbing with yellow line location halfway between the rst/second Spring(10), so eight Springs(10) are attached as shown. Attach four more Springs(10) (not shown) halfway between the rst eight Springs(10). Continue attaching Springs(10) halfway between the previously attached Springs,until all the Springs are attached.
During the installations of spring, wear gloves and protective eye wear.
