6.Using the included plastic tie, attach the Safety Placard (11) to the frame near the point where jumpers will climb onto and off the trampoline.

The trampoline is now fully assembled. Make sure that all parts are securely attached. Familiarize yourself and all users of the tram- poline with the safety precautions, use and

instructional materials, and care and mainte- nance instructions in this manual before using the trampoline.

7.Loosen the straps (not shown) on the underside of the frame pad (for clarity, the frame pad is not shown in the steps 8 and 11). Do not remove the frame pad from the trampoline.

See the inset drawing.

8.Lay a Bottom enclosure pole(16) and a Top enclo- sure pole (17) with Plastic Cap on the ground.

Make sure that the Bottom enclosure pole(16) is oriented so the small holes are in the position shown. Slide a Foam Sleeve(21) onto each of tubes; note that the ends of Bottom enclosure pole(16) should not be covered.

Insert the Bottom enclosure pole(16) into the Top enclosure pole(17). Tighten a Self-tapping Screw(12) into the small hole in the Enclosure pole(16 & 17).

Assembly the remaining Bottom enclosure pole(16), Top enclosure pole(17), and Foam sleeves(21) in the same way.

9.Slide a ‘WEDGE’(23) onto the Botom enclosure pole (16), the top of the ‘Wedge’(23) should touch the bottom of the T-Connector(4), and that the bottom of the ‘Wedge’ (23) should be even with the bottom of the Bottom enclosure pole.

Slide one of the U-bolts(15) up until it touches the bottom of the T-connector(4), and tighten the two Locknuts(13) on the U-bolt. Slide the other U-bolt up until it is 2” above the lower end of the Botom enclosure pole,and tighten the two Locknuts on the U-bolt. Then, press two U-bolt Plastic Caps(24) onto each U-bolt.

6

 

 

 

 

 

 

 

 

Frame

 

 

 

 

 

 

11

 

7

 

 

 

 

 

 

 

 

13

Socket

 

 

 

 

14

 

 

 

13

 

 

 

15

 

 

 

 

14

 

 

 

 

 

 

 

 

 

 

5

 

 

15

 

 

 

 

 

14

 

 

 

 

24

13

 

 

 

 

 

 

 

 

 

 

 

U-bolts

 

8

 

16

 

 

 

 

 

 

 

 

 

 

 

21

 

 

16

 

 

 

17

 

 

 

 

 

 

 

21

Small Hole

21

 

 

 

 

 

Plastic Cap

 

 

 

 

 

(19)

 

 

 

 

21

 

 

 

12

 

 

 

Tighten Self-tapping Screw

Plastic Cap

(19)

Into Small Hole

 

 

 

9

 

 

 

 

 

 

 

 

 

17

 

 

 

 

T-connector

 

 

 

 

24 13

23

 

 

 

 

 

 

 

24

13

15

 

 

 

 

 

 

 

 

 

14

5

 

 

 

 

 

18

Page 18
Image 18
Jumpking OR1213 manual Socket