Jura Capresso ENA 3, ENA 5, ENA 4, 68191 warranty PLEASE, do, Factory Settings

•Never fill frozen beans into the bean container. If you store beans in the freezer, let them thaw 3 to 4 hours before filling them into the bean container.

•Never fill anything other than coffee beans into the bean container (no chocolate, rice, nuts, spices, etc.)

•Never fill anything but fresh, cold clean water into the water container, except when decalcifying (chapter 18.3).

•Never use mineral or carbonated water. You can use tap water, bottled water, spring water, distilled water and reverse osmosis water.

•Never repair or open the machine yourself. All repairs should be performed only by an authorized service center.

•Do not place the machine on a surface which is sensitive to hot or cold water and steam.

PLEASE, DO...

•Fill water tank with fresh, cold water only.

•Remove any foreign particles (small stones) from coffee beans.

•Let frozen beans thaw 3 to 4 hours before pouring them into the bean container.

5. FACTORY SETTINGS

Each machine leaves the factory with the following pre-sets:

•1 Cup – 5 OZ., temp. HIGH, coffee strength (flavor): NORMAL

•2 Cups – 5 oz.(per cup), temp. HIGH, strength (flavor) STRONG

ADJUSTABLE SETTINGS 1 cup from 0.5 to 8 oz.

2 cups from 0.5 to 8 oz. per cup

Note: when using the 2-cup option, ENA will always grind in the STRONG setting.

Please note: You can change all above pre-sets (chapter 14a). You can also override the strengths and the cup size before/ during actual brewing. Overriding will not change the preset values (chapter 9d).

Other functions are set as follows (to change functions refer to
listed chapters.)		chapter
Filter (Clearyl)	– not installed	17.1
Hardness Level	10º dH	16.1
Auto-Off	2 Hours	20
Grinder Fineness	Middle position ....	7
Energy Saving	– not set	19
Unit (Volume)	in OZ	21
Language	English	22

3-Color Display

The ENA features a 3-color alpha-numeric display. This facilitates the use even more.

Green: ENA is ready to prepare a beverage or is in the process of preparing a beverage.

Red: ENA is requiring some kind of action from you to get back to the green display (e.g. FILL WATER TANK)

Yellow: ENA is in programming mode (you pushed the P button). To get out of the programming mode, push the P button again and the display will show the previous information.

6. PREPARING ENA FOR THE FIRST TIME Make sure

•all accessories, literature, caution leaflets etc. are removed from the machine, the water tank, and the bean container.

•the Clearyl Water Filter is NOT installed!

•the machine sits on a flat, even surface and the drawer, tray and used coffee container are inserted (Fig. 1, 12-13).

12.