1.Push and hold the P button (Fig. 4) until the display shows
RINSE.
2.Turn the Rotary Dial until the display shows PRODUCT.
3.Push the Rotary Dial. The display shows WATER.
4.Push the Rotary Dial again. The display shows 5.0 OZ.
5.Turn the Rotary Dial until the display shows 3.0 OZ.
6.Push the Rotary Dial to confirm. The display shows OK and then WATER. You have now set the coffee volume for 1 CUP to 3 oz. Note: when using the
7.Turn the Rotary Dial to FLAVOUR and push the Rotary Dial. The display shows NORMAL.
8.Turn the Rotary Dial until the display shows STRONG and push the Rotary Dial to confirm. The display shows OK and then FLAVOUR.
9.Turn the Rotary Dial until the display shows TEMP.
10.Push the Rotary Dial. The display shows HIGH.
11.Turn the Rotary Dial until the display shows NORMAL and push to confirm. The display shows OK and then TEMP. You have now
12.Push the P button to return to READY.
14b. VISUAL PROGRAMMING OF CUP SIZE
You can also reprogram the cup size visually. READY.
•Place the cup underneath the coffee spout.
•Press and hold down the Rotary Dial until the display reads ENOUGH COFFEE? Then let go. The ENA starts grinding and brewing coffee.
•When the desired amount of coffee is in your cup push the Rotary Dial again. The display shows OK and then READY.
This is now the new programmed volume for the one cup size.
15. WATER CARE
Water is heated inside the machine, this leads to calcium deposits forming. The ENA works with:
• regular tap water • bottled water • distilled water.
We recommend using regular tap water or bottled water. Distilled water has no minerals and does not improve the taste of coffee. Tap water has a varying degree of water hardness (chapter 16).
Most bottled water has a low level of water hardness. IMPORTANT: do not use carbonated water or any other liquid in the water tank.
You have the following options to take care of the water.
•Decalcifying System (chapter 18.3).
•Clearyl Water Filter Cartridge (chapter 17.1).
Your machine is
Please note: The machine will automatically remind you when it is necessary to run certain water maintenance programs. It is important that you follow those instructions. Otherwise your machine may not function properly.
16. WATER HARDNESS MONITOR
Your ENA is set to a water hardness of 10ºdH. The ENA will remind you when it is time to perform a decalcifying cycle. You can change the water hardness setting from 1 to 30dH. If you are not sure about the hardness of your water, ask your local water company for the "Water Hardness in Grains." The machine displays the water hardness in the German hardness scale which is a bit different from the American "Grain" scale (see chart below). You can also use the enclosed water hardness indicator
21.
