K. Replacing the Clearyl Cartridge
When display shows COFFEE READY /CHANGE FILTER and the Rinse button lights up:
•Push Rinse button. DURATION 2 MIN. / START YES.
•Remove water tank, remove old filter. Keep the extension rod. Rinse new filter under running water, attach to extension rod and install in water tank. Fill tank with fresh water and replace.
•Now proceed as explained in steps 4 through 6 above. L) Cleaning with Special Tablet (Machine is on)
The message COFFEE READY / CLEAN MACHINE appears after 220 cups of coffee. This program removes coffee oils inside the machine and takes 20 minutes. Important: Do not interrupt program once started. Important: Only use special round cleaning tablet.
1. Push Rinse button. DURATION 20 MIN. / START YES.
NOTE: To clean the S9 OT later, turn the Rotary Dial until display shows START NO. Push the Rotary Dial to exit the program. In this case the S9 OT will continue to remind you with the message CLEAN MACHINE.
2. Make sure that the water container is at least half full.
3. Push the Rinse Button. EMPTY TRAY.
4. Remove and empty the tray and the used coffee container and replace.
Attention: If the tray and the used coffee container are already empty, you still need to remove the tray for approx. 20 seconds and then replace it. PRESS RINSE.
5. Place containers (20 oz.) under the coffee spout and the frothXpress and push the Rinse button. Display shows CLEANS. After a short while you will hear a beep and display shows ADD TABLET/PRESS RINSE.
6. Open the ground coffee funnel lid and drop one white tablet into the opening. Close lid.
7. Push the Rinse button. Display shows CLEANS. The S9 OT starts the cleaning program by dispensing water in intervals into the containers underneath the spouts. When finished, display shows EMPTY TRAY.
8. Remove the tray. There will be water in the tray and in the used coffee container. Empty, clean and replace. The display shows COFFEE READY.
9. Clean the ground coffee funnel. Remove the funnel and rinse under hot water and dry Replace funnel.
M) Decalcifying DECALCIFY MACHINE
For different water hardness levels see Operating Instructions (page 21). If a water hardness level is selected, the decalcifying monitor is active. The machine needs to be decalcified when above message appears. CAUTION: Immediately remove any splashes of the decalcifying solution from sensitive surfaces, such as natural stone or wood.
CAUTION: If the decalcifying solution comes in contact with the skin, rinse it off with water. If the solution comes in contact with your eyes, see a doctor.
