GE 49-80591-2 Storage drawer Rear drawer support is, Oven will not self-clean Oven temperature is

GEAppliances.com

Problem	Possible Causes	What To Do
Storage drawer	Rear drawer support is	• Reposition the drawer. See the Storage Drawer
is crooked	on top of the guide rail.	Removal instructions in the Care and cleaning
		of the range section.
Storage drawer	Power cord may be	• Reposition the drawer and power cord. See the
won’t close	obstructing drawer	Storage Drawer Removal instructions in the Care and
	in the lower back	cleaning of the range section.
	of the range.
	Rear drawer support is	• Reposition the drawer. See the Storage Drawer
	on top of the guide rail.	Removal instructions in the Care and cleaning of the
		range section.
Oven will not self-clean	The oven temperature is	• Allow the oven to cool to room temperature and
	too high to set a self-clean	reset the controls.
	operation.
	Oven controls improperly set. • See the using the self-cleaning oven section.
	Oven door is not in the locked • Make sure you move the door latch handle all the
	position.	way to the right.
“Crackling” or	This is the sound of the	• This is normal.
“popping” sound	metal heating and cooling
	during both the cooking and
	cleaning functions.
Excessive smoking	Excessive soil.	• Touch the Clear/Off pad. Open the windows to
during a clean cycle		rid the room of smoke. Wait until the light on the
		Self Clean pad goes off. Wipe up the excess soil and
		reset the clean cycle.
Oven door will not	Oven too hot.	• Allow the oven to cool below locking temperature.
unlock
Oven not clean after	Oven controls not properly set. • See the using the self-cleaning oven section.
a clean cycle
	Oven was heavily soiled.	• Clean up heavy spillovers before starting the clean
		cycle. Heavily soiled ovens may need to self-clean
		again or for a longer period of time.
“F –” and a number	You have a function	• Disconnect all power to the range for at least
or letter flash	error code.	30 seconds and then reconnect power. If the function
in the display		error code repeats, call for service.
		• On self-cleaning models, if a function error code
		appears during the self-cleaning cycle, check the oven
		door latch. The latch may have been moved, if only
		slightly, from the locked position. Make sure the latch
		is moved to the right as far as it will go. Touch the
		Clear/Off pad. Allow the oven to cool for one hour.
		Put the oven back into operation.
Water remaining on	This is normal.	• Remove any remaining water with a dry cloth
oven floor after Steam		or sponge.
Clean cycle		35

Safety Instructions

Operating Instructions

Care and Cleaning Troubleshooting Tips Consumer Support