JVC LVT1140-007A manual Getting Started, Before Installation, Checking the Supplied Accessories

Models: LVT1140-007A 0404RYMMDWJEIN

1 42
Download 42 pages 59.8 Kb
Page 7
Image 7
 Getting Started

Before InstallationNotes: Getting Started

This section explains how to connect audio/video components and speakers to the receiver, and how to connect the power supply.

Before Installation

General Precautions

Be sure your hands are dry.

Turn the power off to all components.

Read the manuals supplied with the components you are going to connect.

Locations

Install the receiver in a location that is level and protected from moisture and dust.

The temperature around the receiver must be between –5˚C and 35˚C.

Make sure there is good ventilation around the receiver. Poor ventilation could cause overheating and damage the receiver.

Notes:

Supplied batteries are for the initial setup. Replace for continued use.

For RX-6042S: After replacing the batteries, set the manufacturers’ codes again (see pages 35 and 36).

CAUTION:

Follow these precautions to avoid leaking or cracking cells:

Place batteries in the remote control so they match the polarity: (+) to (+) and (–) to (–).

Use the correct type of batteries. Batteries that look similar may differ in voltage.

Always replace both batteries at the same time.

Do not expose batteries to heat or flame.

Handling the receiver

Do not insert any metal object into the receiver.

Do not disassemble the receiver or remove screws, covers, or cabinet.

Do not expose the receiver to rain or moisture.

Do not connect the AC power cord until all other connections have been made.

Checking the Supplied Accessories

Check to be sure you have all of the following items, which are supplied with the receiver.

The number in the parentheses indicates quantity of the pieces supplied.

Remote Control (1)

Batteries (2)

AM Loop Antenna (1)

FM Antenna (1)

If anything is missing, contact your dealer immediately.

Putting Batteries in the Remote Control

Before using the remote control, insert the two supplied batteries first.

1

2 R6(SUM-3)/

3

 

AA(15F)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1Press and slide the battery cover on the back of the remote control.

2Insert the batteries.

• Make sure to match the polarity: (+) to (+) and (–) to (–).

3Replace the cover.

Connecting the FM and AM Antennas

FM antenna connections

AB

AM

AM

EXT

EXT

AM

AM

LOOP

LOOP

75

ANTENNA

75

ANTENNA

 

 

COAXIAL

 

COAXIAL

 

FM

 

FM

 

Extend the supplied FM antenna horizontally.

AM

Checking the Supplied AccessoriesEXT

AM

LOOP

FM Antenna (supplied)

FM 75

 

 

COAXIAL

 

Outdoor FM Antenna Cable

 

ANTENNA

 

(not supplied)

 

 

Connect the supplied FM antenna as temporary measure to the FM 75 COAXIAL terminal—A

If reception is poor, connect the outdoor FM antenna (not supplied)—B

1Disconnect the supplied FM antenna.

2Connect a 75 coaxial cable with the standard type connector

(IEC or DIN45325).

If the remote control cannot transmit signals or operate the receiver correctly, replace the batteries. Use two R6(SUM-3)/AA(15F) type dry-cell batteries.

5

Page 7
Image 7
JVC LVT1140-007A manual Getting Started, Before Installation, Checking the Supplied Accessories, 2Insert the batteries